TiMCO C2 TORX Clamp-Fix Screws – Tubs

The TiMCO C2 TORX Clamp-Fix screw tubs are built around one specific problem: timber jacking. When you drive a standard screw into a timber-to-timber joint, the upper piece can lift rather than clamp down. The C2 is engineered to stop that happening, pulling the top board tight against the substrate and holding it there. If you work with decking, structural timberwork, or any application where a flush, secure joint actually matters, these are the screws to reach for.

The twin-cut point gives rapid pick-up without the usual wrestling match to get the screw started. It bites cleanly, reduces the risk of splitting, and drives consistently every time. The precision TORX recess is tight enough to prevent cam-out, so you stay in control on every single drive. No slipping, no stripped heads, no ruined timber. Anyone who has ever put a Phillips screw through the face of a decent board will appreciate that more than most.

What Makes the TiMCO C2 TORX Clamp-Fix Worth Using

The dual angle thread is what delivers the pull-out resistance. It grips timber hard and holds under load, which matters on structural fixings and anything subject to movement or seasonal expansion. Ribs under the head aid countersinking and leave a clean, flush finish without the surface damage you can get from screws that lack them.

The high-molecular polymer lubricant coating does two jobs at once. It cuts insertion torque by up to 52% compared to an uncoated screw, which your wrist will thank you for at the end of a long day, and it increases rust protection up to 20 times beyond standard zinc plating. For external timber work or anywhere moisture is a factor, that is a significant advantage.

Available in tubs across a wide size range from 3.0 x 12mm up to 8.0 x 420mm, with box quantities suited to trade volume. The timco c2 torx screw tubs format keeps things tidy on site and makes restocking straightforward.