Premier Diamond P6-LMCM PRO Combo Blade for CONCRETE & ASPHALT

The Premier Diamond P6-LMCM PRO Combo Blade is engineered for operators who need to cut concrete and asphalt consistently, at pace, and without burning through blades. The design priority is straightforward: lowest cost per cut, combined with the kind of blade life that makes it viable for demanding site work. Whether you are cutting through general purpose concrete, heavily reinforced slabs, or asphalt laid over concrete, the P6-LMCM PRO handles the transition without needing a blade change. That alone saves time and reduces on-site faff considerably.

The deep draft segment geometry is the key detail here. When cutting deeper into asphalt or highly abrasive materials, the segment profile protects the steel core from premature wear. This matters on longer cuts where heat and abrasion are building up, and where a shallower segment would begin to undercut and lose contact with the core. The P6-LMCM PRO is designed to hold its integrity through exactly those conditions.

This blade covers a wide range of masonry and construction materials beyond concrete and asphalt. Bricks from standard facing through to Class A engineering, clay products, sandstone, York stone, cement screed, concrete flagstones, kerbs, pipes and beams, concrete roof tiles, and block paving all fall within its cutting range. Green concrete up to 24 hours old is also listed, which is useful when formwork needs to be removed or modified quickly after a pour. The blade is available in four sizes: 300mm x 20mm, 350mm x 25.4mm, 400mm x 25.4mm, and 450mm x 25.4mm, covering floor saws, cut-off saws, and disc cutters across a range of common bore sizes.

Where the Premier Diamond P6-LMCM PRO Combo Blade Gets Used

On site, this blade is the sensible choice for any job where the material specification is mixed or uncertain. Road and civils work regularly involves asphalt over concrete, and a dedicated asphalt blade or a pure concrete blade will compromise in one direction or the other. The P6-LMCM PRO is specifically rated for asphalt over concrete as a combined cut, not just each material separately.

It also performs well in general groundworks, utility installation, and building strip-out, where a range of concrete densities and brick types may be encountered in the same cut. Lightweight concrete blocks, medium density blocks, and solid density blocks above 12 Newton are all within the blade’s rated scope, making it a practical choice when block density is unknown or variable.

Segment Design and Core Protection

The deep draft segment specification addresses one of the more common causes of blade failure in abrasive materials: the segment wearing below the steel core before the diamond layer is exhausted. By extending the segment depth, Premier Diamond allows the cutting surface to wear down through a greater range before the core becomes exposed. The result is a more consistent cut profile throughout the blade’s working life, and less likelihood of unexpected core damage mid-job.

The Premier Diamond P6-LMCM PRO Combo Blade represents a practical, well-considered tool for operators dealing with concrete, asphalt, or any combination of the two on a regular basis.