Blue Dolphin Orange Rough Surface Masking Tape is built for high-adhesion work on brick, block, concrete, stone and grout. Rated for exterior use, it holds where standard masking tape gives up. 48mm wide, 50m roll.
Trade QTY discounts — the more you buy, the more you save
Quantity
Discount
You Save
Price/unit
Buy 24 – 47
3%
£0.13£0.16
£4.36£5.23
Buy 48+
5%
£0.22£0.26
£4.27£5.12
Discount applies across all variants of this product.
Add 24 to unlock 3% off
024+48+
Most masking tape is fine on smooth, painted surfaces. Put it on rough render, exposed brick or concrete and it lifts at the edges within the hour. Blue Dolphin Orange Rough Surface Masking Tape is specifically made for those surfaces, and it does the job properly. At 48mm x 50m, this masking tape 48mm roll is a solid choice for decorators, plasterers and builders who need clean lines on surfaces that would defeat ordinary tape.
The orange colour is not just for looks. On a busy site it makes the tape easy to spot, easy to remove, and harder to accidentally paint over and forget. The higher-tack adhesive bonds well to open-textured surfaces like block, stone, grout lines and rough concrete without leaving residue behind when it is taken off cleanly.
Where Blue Dolphin Orange Masking Tape Gets Used
This is the tape plasterers and renderers reach for when they need to protect an adjacent surface during application. It is equally useful when painting around brickwork, masking window sills on new builds, or protecting stone coping during pointing work. The 48mm width gives a decent coverage margin, which saves time when you are masking along a long run of blockwork or a rough rendered wall.
Exterior and Wet Environment Use
This tape is rated for exterior use, meaning it handles site conditions that would cause a standard crepe tape to fail fast. Wind, dust and light moisture are not a problem. It is not a long-term weatherproof solution, but it will stay put for the duration of a typical job without needing constant re-application.
For any trade work where you need a masking tape 48mm wide that actually sticks to rough and porous surfaces, this Blue Dolphin tape is a reliable choice that earns its place in the bag.
Pro Tip: Remove this tape while the paint or render is still slightly tacky rather than fully cured, as pulling it from rough surfaces when everything is bone dry can lift material from the substrate edge.
Blue Dolphin Orange Rough Surface Masking Tape is used across decorating, plastering and general building work wherever standard masking tape will not hold. It is the go-to choice for protecting brickwork, concrete blocks, stone, grout joints and rough-textured render during painting or application work. Exterior use on new builds, renovation projects and pointing jobs is well within its capability, and the 48mm width suits most masking runs without needing multiple passes.
Best For
Rough and porous surfaces
Brick, block and concrete masking
Stone and grout line protection
Exterior decorating and rendering
High-adhesion masking applications
Compatible Surfaces
Brick
Concrete block
Stone
Grout
Rough render
Textured exterior surfaces
Key Features
High-tack adhesive for rough surfaces
48mm wide for good coverage margin
50m roll length
Suitable for exterior use
High-visibility orange colour
Clean removal without residue
Not suitable for: Not suitable as a long-term weatherproof seal or for permanent bonding applications. Not intended for use on freshly painted or delicate surfaces where the higher-tack adhesive may cause damage on removal.
Clean loose debris and dust from the surface before applying. Press the tape down firmly along its full length, paying attention to the edges, as this is where rough surfaces tend to cause lifting. On very open or dusty substrates, a quick wipe down makes a noticeable difference to how well it beds in.
Remove the tape at a low angle while the applied material is still slightly green if possible. Pulling at 45 degrees or less reduces the risk of dragging material from the substrate edge on coarser surfaces.
Brush or wipe loose dust and debris from the surface before applying the tape
Tear or cut the tape to the required length
Apply along the masking line, pressing the full width down firmly as you go
Run a finger or thumb along both edges to ensure adhesion on the rough texture
Complete the paint, render or pointing work and allow to reach a slightly tacky or green stage
Remove the tape at a low angle, pulling back on itself steadily to get a clean edge
Will this tape stick to rough concrete and brick without lifting?
Yes, that is exactly what it is designed for. The higher-tack adhesive grips open-textured and porous surfaces where standard masking tape loses contact at the edges. Pressing the tape down firmly on application helps it seat properly into the surface texture.
Can I use Blue Dolphin Orange Masking Tape outside?
It is rated for exterior use and will handle typical site conditions including wind, dust and light moisture. It is not a long-term waterproof product, but it will hold reliably for the duration of a standard job without lifting or falling away.
Does it leave residue on brick or stone when removed?
When removed correctly, it should come away cleanly without leaving adhesive residue. Remove it while the applied material is still slightly tacky rather than waiting for everything to fully cure, as this makes clean removal much easier on rough and porous surfaces.
Blue Dolphin Orange Rough Surface Masking Tape uses a higher-tack adhesive system on a crepe paper backing, engineered to conform to and grip irregular, open-textured surfaces. The 48mm width and 50m roll length are a standard trade size suited to professional decorating and building applications. The orange pigmentation provides high site visibility. The tape is formulated for exterior conditions and clean removal from masonry and stone substrates.
Brand
Blue Dolphin
Width
48mm
Length
50m
Colour
Orange
Surface Type
Rough and porous surfaces
Use
Interior and exterior
Backing
Crepe paper
Reviews
There are no reviews yet.
Be the first to review “Blue Dolphin ORANGE Rough Surface Masking Tape – 48mm x 50m”Cancel Reply
Reviews
There are no reviews yet.