A complete 9 inch roller frame and tray set including five durable woven fabric sleeves with a 12mm pile. Suits emulsion, water-based and undercoat paints on smooth and semi-rough surfaces. Frame has a thumb rest, moulded handle, and reinforced screw-fit extension pole fitment.
This 9 inch roller frame and tray set gives you everything you need to get straight on with the job. Five woven fabric roller sleeves with a 12mm pile are included, which suits most standard interior work — emulsion, water-based paints, and undercoat on smooth to semi-rough surfaces. That is a decent amount of coverage from a single purchase before you even think about ordering more sleeves.
The frame itself is well thought out for a day’s work. A moulded handle keeps your grip comfortable over extended runs, and the thumb rest gives you extra control when cutting in along edges or rolling out large flat areas. The push-fit system makes swapping sleeves quick, and when you need more reach, the screw-fit fitment accepts a standard extension pole. Handy for ceilings, or for anyone who would rather not be up a step ladder for four hours.
What You Get with This 9 Inch Roller Frame and Tray Set
The tray is shaped to distribute paint evenly across the sleeve as you load up. It is a straightforward moulded tray, solid enough for regular use and easy to clean down at the end of the day. The five sleeves in the pack give you backup if one gets caked up mid-job, or enough to rotate across a multi-room repaint without stopping to rinse out constantly.
At 9 inches wide, this roller covers ground efficiently on walls and ceilings without the awkwardness of a wider roller in tighter spaces. The 12mm pile works well on most plastered and lined surfaces where you want a reasonably smooth finish without burning through paint. It is not a specialist nap for rough masonry or fine gloss work, but for the bulk of everyday interior painting it performs exactly as expected.
Good for decorators working through a schedule of rooms, and equally useful for tradespeople who need a reliable set on site without putting much thought into it. Five sleeves, a solid frame, and a tray. Get rolling.
Pro Tip: When loading the sleeve, roll it back through the ribbed section of the tray three or four times before starting on the wall — a properly loaded sleeve lays paint far more evenly from the first stroke and reduces the patchy first-pass problem.
This set is used primarily for interior wall and ceiling painting with emulsion and water-based undercoats. It covers smooth plaster, dry-lined walls, and lightly textured surfaces with ease. Decorators use it for full room repaints, preparing walls before wallpapering, or applying primer coats prior to a finish paint. The 9 inch width is the standard choice for most domestic and light commercial interior work, and the five included sleeves make it a practical option for multi-room jobs or sites where a quick sleeve swap is more efficient than rinsing out mid-task.
Best For
Interior walls and ceilings
Emulsion paint application
Water-based undercoats
Standard interior repaints
Multi-room decorating jobs
Compatible Surfaces
Smooth plaster
Dry-lined walls
Semi-rough surfaces
Lined and prepared walls
Painted ceilings
Key Features
12mm pile woven fabric sleeves
5 sleeves included
Moulded comfort handle
Thumb rest for control
Push-fit sleeve system
Reinforced screw-fit extension pole fitment
Includes paint tray
Not suitable for: Not suitable for solvent-based or oil-based gloss paints, which require a short-pile foam or mohair sleeve. The 12mm pile is also not ideal for very rough masonry or exterior textured coatings, which need a thicker nap to get paint into the surface properly.
Fit a sleeve onto the roller cage by pressing it firmly onto the frame until it seats against the end caps. Pour a reasonable amount of paint into the deep end of the tray, then load the sleeve by rolling it through the ribbed section several times until it is evenly coated but not dripping. Apply paint in overlapping W or M strokes, then finish with light vertical strokes to even out the coverage.
When switching sleeves, pull the used one off the cage and replace with a fresh one. At the end of the job, remove excess paint from the tray and sleeves before washing through with warm water. If you are using an extension pole, screw it into the handle fitment firmly before starting — a loose pole on a ceiling is exactly as annoying as it sounds.
Stir paint thoroughly before pouring a working amount into the deep end of the tray
Fit a roller sleeve onto the frame cage, pressing firmly until it seats against both end caps
Load the sleeve by rolling it back and forth across the ribbed section of the tray until evenly coated
Apply paint to the surface in overlapping diagonal strokes to distribute coverage
Finish each section with light, parallel strokes in one direction to smooth out the finish
Swap sleeves as needed rather than overworking a clogged one mid-wall
Screw on an extension pole for ceiling work before starting — do not try to add it while loaded with paint
Clean tray and sleeves with warm water immediately after use while paint is still wet
Will these sleeves work with solvent-based or oil gloss paints?
No. The woven fabric sleeves in this set are designed for water-based products: emulsion, water-based undercoat, and similar finishes. For solvent-based gloss or eggshell, you would need a short mohair or foam sleeve rated for solvent use. Using these sleeves with oil-based paints will likely cause the fabric to break down and shed fibres into your finish.
Does the frame fit a standard extension pole?
Yes. The handle has a reinforced screw-fit fitment at the end that accepts standard threaded extension poles. Most decorator poles with a standard thread will fit. Worth giving it a firm tighten before you start on a ceiling — a pole that works loose mid-stroke is a paint-on-the-floor situation waiting to happen.
The roller sleeves feature a woven fabric construction with a 12mm pile depth, suitable for smooth to semi-rough interior surfaces. The frame cage is designed for push-fit sleeve changes and includes a moulded ergonomic handle with an integrated thumb rest for improved control during extended use. The handle incorporates a reinforced threaded fitment compatible with standard screw-fit extension poles. Paint tray is moulded with a ribbed loading section for consistent sleeve saturation.
Reviews
There are no reviews yet.