WRAS Rated End Feed Fittings Packs – 300 to 950 Fittings

These end feed fittings packs are put together for plumbers and heating engineers who go through volume on site and don’t want to be placing small orders every other week. Every fitting in every pack carries WRAS approval, which means they meet the Water Regulations Advisory Scheme requirements for use on potable water systems in the UK. That’s not optional on a lot of jobs, and it’s worth knowing it’s covered before you start rather than after.

Each end feed fittings pack is built around the fittings you actually reach for most often: 15mm and 22mm couplers, elbows, and equal tees, plus 22x15mm reducing fittings to bridge the two sizes. The ratio of elbows to couplers reflects the reality of most plumbing runs, where direction changes happen more often than straight joins. The packs aren’t just a round number of random fittings thrown in a box.

End Feed Fittings Pack Options

Pack 1 contains 475 fittings and is weighted towards 15mm work, with 100 couplers, 200 elbows and 50 equal tees at 15mm, alongside 50 couplers, 50 elbows and 25 reducers at 22mm. This suits domestic heating and hot and cold pipework installations where 15mm runs are dominant.

Pack 2 is the smallest option at 300 fittings and offers a more balanced spread across 15mm and 22mm, including 22mm equal tees. It’s a practical top-up pack or a good starting point for a smaller job.

Pack 3 steps up to 575 fittings and includes 22mm equal tees alongside the full range of 15mm and 22mm couplers, elbows and reducers. This is a solid choice for a medium-scale installation or a busy week on site.

Pack 4 is the largest at 950 fittings and is weighted heavily towards 15mm elbows, with 400 in the pack. This makes sense for complex runs with lots of directional changes, such as underfloor heating feed pipework or multi-room domestic installs. The 22mm content covers the main distribution side.

End Feed Fitting Quality and Compliance

End feed fittings rely entirely on the solder applied by the installer for a watertight joint, unlike solder ring fittings which carry their own solder charge. That means joint quality depends on clean pipe, proper flux application and correct heat. These fittings are made from dezincification-resistant brass where required to meet WRAS standards, which is relevant wherever they may be in contact with drinking water. WRAS approval confirms the material composition and construction have been independently assessed against the Water Supply (Water Fittings) Regulations 1999.

Buying fittings as a pack rather than individually reduces cost per fitting considerably and means you’re not short on a standard elbow or coupler at an inconvenient moment. For plumbers working across multiple domestic properties or on a new build programme, having a stock of end feed fittings packs on the van is standard practice.