SDS+ Auger Bit – 5pc Set -200mm

This 5 piece 200mm SDS auger bit set covers the sizes you actually reach for on site — 10mm, 13mm, 19mm, 22mm and 25mm — all at 200mm length, which gives you enough reach for joinery work, stud walls, floor runs and most cable or pipe routing jobs. Each bit uses a specialist screw-in point that does the pulling for you, drawing the bit through the timber rather than relying on brute force. That means faster progress and cleaner exit holes with less blowout on the back face.

The cutting edges are ground and sharpened specifically for wood drilling, not adapted from masonry geometry. That distinction matters more than it sounds. A properly shaped wood auger clears chips efficiently and holds its line through grain changes. These do what they’re supposed to do, which is not something you can take for granted at this price point.

Where This SDS Auger Bit Set Gets Used

The SDS+ shank means these go straight into any rotary hammer drill — though the hammer action must be switched off. Run them in rotation-only mode and they work a treat through most timber-based materials. First fix electrics and plumbing, drilling through joists or studwork, running cables through wall plates, installing pipework through timber frames. That’s the daily grind for these bits, and the 200mm length handles most of it without needing an extension.

Materials These Bits Handle Well

Soft and hardwood are the obvious ones, but the set also performs well in plywood, particle board, MDF and chipboard. The screw-in point gives good bite in manufactured boards that can sometimes wander under a standard twist drill. Laminated or resin-heavy boards may blunt the tips more quickly, so keep that in mind if you’re drilling engineered hardwoods regularly.

At under seventeen pounds for five bits you can actually use, this is a sensible grab-and-go set for any van. Whether you’re a first fix sparky or a plumber chasing pipework through joinery, the 5 piece 200mm SDS auger bit set earns its place in the bag.