End Feed end cap

The end feed end cap is one of those fittings that does exactly what it says and asks nothing in return. You solder it on, the pipe is terminated, job done. Available in 8mm, 10mm, 15mm, 22mm and 28mm, these WRAS approved end feed end caps cover the copper pipe sizes you’ll encounter on the vast majority of plumbing jobs across domestic, commercial and light industrial settings.

WRAS approval matters here. It confirms the fitting meets Water Regulations Advisory Scheme requirements for use in contact with potable water, so there’s no question mark hanging over it when you’re working on drinking water systems. Specifiers, building control and end clients increasingly ask for WRAS approved fittings as standard, and these tick that box without any fuss.

End Feed End Cap Applications on Site

End feed fittings suit plumbers who are confident with a blowtorch and flux. The fitting itself has no integral solder ring, so you apply flux, push the cap onto the pipe end, apply heat and feed solder in at the joint mouth. It gives you full control over the solder quantity, which experienced plumbers often prefer. The result is a clean, permanent termination that won’t budge.

Whether you’re capping off a redundant supply, blanking an unused port on a manifold, or tidying up during a bathroom or kitchen refit, these fittings handle it cleanly. At this price point, keeping a small stock of each size on the van makes sense. Running out of a 15mm end cap is one of those small annoyances that adds up over a week.

These are straightforward copper end feed fittings made to perform reliably in standard pressurised pipework systems. No complications, no adapters needed, just a solid solder joint and a terminated pipe.